menuMENU    UK Free TV logo Archive (2002-)

 

 

Click to see updates

TVs and boxes that do not support the 8k-mode

Here is the list from Digital UK of boxes and sets that will not receive Freeview after switchover is complete

Here is the list from Digital UK of boxes and sets that will no
published on UK Free TV

If you use one of these to watch Freeview, or are hoping to after switchover happens in your region, you will need to get a new Freeview box at switchover.

ONdigital/ITVdigital branded set top boxes

Nokia Mediamaster 9850T; Pace DTR730 and DTR735, Philips DTX6370, DTX6371 and DTX6372; Pioneer DBRT200 and DBRT210, Sony VTX-D500; Toshiba DTB2000.

If you have any of these you will need to recycle it and get a new box.

Freeview branded set top boxes

Fusion FRT100*, Pace DTVA-T "Wedge Adaptor", DT210F*, Samsung SIRU200i (Without M suffix).

Freeview, ONdigital and ITV branded integrated digital television sets

Alba ONdigital sets, Bush ONdigital sets.

Hitachi 28WDDODTN, 32WD40DTN and D36W840DTN; Panasonic TX-28DT2, TX-32DT2, TX-28DT30*, TX-32DT30*, TX-36DT30*, TX-36DT35* and TX-32DH40*; Philips 28DW6734, 32DW6834, 32DW9625, 28DW6557* and 32DW6557*.

Sanyo CE28DFN1-B, CE32DFN1-B, CE28DFN2-B, CE32DFN2-B, CE32DFN2BK-B, CE28DWN1-B, CE28DFN3-B-00, CE32DFN3-B-00, CE30LD3-B,CE30LD3BK-B, CE27LD3-B, CE23LD4-B, CE23LD4W-B, CE27LD4-B, CE27LD4BK-B, CE32LD4-B, CE32LD4BK-B, CE27LD5-B and CE32LD5-B.

Sony 28DS60, 32DS60, 28DS65, 32DS65, 28DX20, 32DX20, 28DX30, 32DX30, 28DS20, 32DS20, KP41DS1, KP51DS1, KP51DS2, KP41DS1, KP51DS1, KP51DS2, KD28DX40*, KD32DX40*, KD32DX100*, KD32NX100*, KD32NX200*, KD36NX200*; Toshiba 28WT98B, 32WT98B, 28ZT29B, 32ZT29B, 36ZT29B, 42WT29B, 50WT29B and 57WT29B.

All these sets can be upgraded - contact the supplier (numbers below) to add a Freeview box to the set.

Boxes that do not support both 2k and 8k modes

Some boxes are having problems during switchover supporting both modes at the same times:

  • Sharp TU-R160H
  • Humax 9200T
  • Thomson DTi 1000


The workaround appears to be to add the "8k" channel manually (C62 for Selkirk, for example) and then to do this procedure after switchover is complete: My Freeview box has no EPG, is missing Film4, Channel 4+1, no sound on ITV3 or the channel line up is wrong - ukfree.tv - independent digital television and switchover advice, since 2002

This is on top of the boxes that could not cope with the changes to the Network Information Table (NIT): Daewoo DS608P, Labgear DTT100, Triax DVB 2000T, Portland DP100 and these VCR/STBs: Daewoo SV900, Bush IDVCR01

Helpline numbers

  • Alba 0871 230 1777
  • Bush 0871 230 1777
  • Daewoo 0870 100 2525
  • Hitachi 0870 405 4405
  • Humax 0870 247 8800
  • Nokia 0845 045 5555
  • Pace 0870 120 1910
  • Panasonic 0800 169 3012
  • Philips 0870 900 9070
  • Pioneer 0330 123 1240
  • Sharp 08705 274 277
  • Sony 08705 111999
  • Thomson 01443 220220
  • Toshiba 0115 976 6958


Help with Freeview, aerials?
How do I get a test card with Freeview1
I would like to know if it is possible to receive UK terrestrial Freeview servic2
I have been told I would receive too much singal from my Freeview tansmitter as 3
Can my Freeview box receive more than one BBC and ITV region?4
Is it true that my 87 year old mother is entitled to a FREE upgrade when the ana5
In this section
Should the UK close down the TV networks to allow for more mobile broadband? 1
UK Digital switchover ends - Northern Ireland completes on 24th October 20122
The last day of analogue television in the UK - goodbye PAL3
2 days left of analogue television - goodbye teletext4
3 days of analogue to go - goodbye to NICAM 7285
Changes to Saorview frequencies and power levels, 24th October 20126

Comments
Saturday, 28 April 2012
Dave Lindsay
sentiment_very_satisfiedPlatinum

2:53 PM

sgk: The box is of no use after switchover.

The design did not extend to full compliance with the DVB-T specification which is what is used for standard definition broadcasts in the UK. It was only ever designed to work in 2k mode and not 8k mode.

The broadcasters or regulators don't offer any recompense to owners of devices that don't fully comply with the DVB-T specification.

link to this comment
Dave Lindsay's 5,724 posts GB flag
Friday, 1 June 2012
D
D Ruff
10:06 AM

I have to manually re tune our Tv as automatic only goes to 29.
Our ariel faces London although we live in Burgess Hill.Most of our neighbours are IOW.transmitter
As soon as we turn off the TV at the end of the day,we lose all the channels again.utterly fed up with retuning.Seems like a ruse to get us spending money.

link to this comment
D Ruff's 1 post GB flag
Dave Lindsay
sentiment_very_satisfiedPlatinum

10:23 AM

D Ruff: It would be helpful to know more about your situation. In particular, what is the model of the TV? Is it Crystal Palace that you are using?

If by "only goes to 29" means that the scan stops at C29, then I wonder if this has something to do with the fact that Crystal Palace's C28 has a negative offset and that this set can't handle it. If you provide a make and model number this might help because chances are that someone else has encountered the same problem.

link to this comment
Dave Lindsay's 5,724 posts GB flag
Sunday, 3 June 2012
B
BH Viewer
3:20 PM

D Ruff:
Most people in BH are using either the Heathfield or Midhurst transmitters, which should give you a more resilient service than Crystal Palace. I doubt if your neighbours are receiving signals from Rowridge (Isle of Wight) - the South Downs are in the way.

Dave's point regarding frequency offsets is valid. Also, Heathfield Mux 2 is currently on Ch29 (on low power but with no offset) until 13 June when the digital switchover will be complete.

Try a good quality Group B (for Heathfield) or Group C/D (for Midhurst) aerial rather than a DIY store 'wide-band' or so-called 'digital' aerial.
Heathfield will give you BBC South East, whilst Midhurst carries BBC South.

link to this comment
BH Viewer's 6 posts GB flag
J
jb38
sentiment_very_satisfiedPlatinum

5:14 PM

D Ruff: With regards to your TV losing channels after having been switched off, then this is usually caused by the TV trying to store more channels than its memory capacity is capable of doing, hence when the set is unpowered they drop out.

The only way to get around that problem is by either carrying out a "factory reset" on the TV this sometimes called "default setting" on some devices, or alternatively proceeding as though you were going to carry out another auto-tune but exiting it as soon as you press "search" or "scan", as that wipes out anything stored in the memory without upsetting any other settings, but no matter what method you use carry out a normal auto-tune after having blanked the channels out.

And as was mentioned by Dave Lindsay, it would be of assistance to know the model number of the TV in question so that certain aspects of its tuners specifications to be checked out.


link to this comment
jb38's 7,179 posts GB flag
Friday, 29 June 2012
B
barry woodward
2:49 PM

I have a perfectly good aerial which gives me excelent picture from an outside areial,
so if I wait for the switchover in september will I get switched over without getting a digital aerial put up. I do not want freeview anyway and I am watching tv on a widescreen phillips silver tv I bought in 2003

link to this comment
barry woodward's 1 post GB flag
Dave Lindsay
sentiment_very_satisfiedPlatinum

3:08 PM

barry woodward: There is no such thing as a "digital aerial". Aerials work based on frequencies used and don't care whether signals are of analogue or digital form.

In some cases aerials need to be replaced because the signals used for post-switchover digital are different to those use for former analogue.

If you post your location, preferably in the form of post code or nearby post code (e.g. a shop), then we can advise whether you will be likely to be affected. It is generally a good sign that it works now, but knowing which transmitter you are using will help us to be more sure whether your current aerial is likely to work after switchover.

If you know which transmitter you use or which direction your aerial points, that may help, along with the location.

link to this comment
Dave Lindsay's 5,724 posts GB flag
Sunday, 2 September 2012
M
Michael
sentiment_satisfiedGold

11:27 AM

GRUNDIG GULENAR 26HDIP FREEVIEW TV - COPY OF MY EMAIL TO GRUNDIG - Can you please tell me what to do here.

I have a Grundig GULENAR26HDIP Freeview TV Set where certain freeview channnels freeze.

I understood that if i left the TV on standby all night that the problem would be fixed in the form of some sort of software update that was released in 2011.

This has not cured the fault the tv freezes up as soon as an itv channel is selected & will not respond to anything at all until the power is fully turned off.

Can you please advise me on how to rectify this fault as it is spoiling a perfectly good TV.

I cannot use it like this,

Regards,

Michael


link to this comment
Michael's 368 posts GB flag
Saturday, 15 September 2012
P
Peter Coyle
4:25 PM

My parents have a Hitachi 42PD6700 U as their main TV. After the first stage of changeover the BBC channels are distorted but other channels are OK. Tried switching aerials,using attenuators etc to no avail. Another TV (newer Samsung works fine in same place so fault points to Hitachi. Any chance problem will clear after second part of changeover on Pontop Pike transmitter

link to this comment
Peter Coyle's 4 posts GB flag
Dave Lindsay
sentiment_very_satisfiedPlatinum

6:57 PM

Peter Coyle: Check that the Hitachi is tuned correctly, to Pontop Pike for BBC on UHF channel 58. Do this by viewing the signal strength screen.

It is possible that it has decided to go with the signal from another transmitter. Overlap is much more a possibility now that the BBC digital signals are on full power.

If it turns out that it has gone with another transmitter, then a workaround may be to unplug the aerial for the first part of the scan. It depends on whereabouts within the UHF channels that it has tuned to (they run 21 to 69).

From 26th September, Pontop Pike's lowest will be C49, so have the aerial in for that. Get the aerial in for 55% should do it. This will work if the signal that you're trying to avoid is much below C47.

link to this comment
Dave Lindsay's 5,724 posts GB flag
Select more comments

Your comment please
Please post a question, answer or commentUK Free TV is here to help people. If you are rude or disrespectful all of your posts will be deleted and you will be banned.







Privacy policy: UK Free Privacy policy.