All posts by Brian Greensides
Below are all of Brian Greensides's postings, with the most recent are at the bottom of the page.
B
Sandy Heath (Central Bedfordshire, England) Full Freeview transMonday 12 September 2011 8:22PM
March
Brian Greensides here. OK Briantist, thanks for the reply, just a couple of things.
What is the significance of the + symbols on channels 21+ and 40+ (are these the different modes)and What mode will they be as of Wednesday(14/9/11) ie 2K or 8K
Thanks once again.
Brian
| link to this comment |
I am in March post code PE159NZ. My loft aerial is pointing to Sandy Heath (Bearing 204 degrees)as you would expect. The aerial feeds a 6 way distribution amp. The lounge TV has a Humax 9300T PVR and Mux channels 27,24,21,31,67,48 all work fine. Now for the odd ball. One of the amp outputs feeds a AVER Media DVB-T card in my PC. and I'm using Windows Media Centre. When I checked some of the mux,s are as expected, but PSB1 is tuned to 794 mhz, which I beleive is the Waltham Txr. The signal is strong and quality 100% When I checked the map, Waltham is about 90% further north from March. Can you explain what may be going on please
Brian Greensides
| link to this comment |
Thanks for the reply Dave. I have been delving into Windows Media Centre, and I believe that different TX'ers can be selected provided that they were detected during the original tunning scan. The bit I found odd was that the Loft aerial is directed to Sandy Heath and yet I'm getting (In addition) strong signals from Waltham (90 degrees further North)!!!
Incidentally can you please confirm as of tomorrow the sandy Heath channels will be 27,24,21,51,52,48
Regards Brian
| link to this comment |
Thank you, I'll do a full retune on all (Wipe all original stuff first) systems (3 TV's 1 PVR and 1 PC)
Thanks again for the advice (great forum)
Brian
| link to this comment |
Adam, thanks for pointing that out (I was aware just copied the wrong channel from my spreadsheet, which shows the mux channels and the change over dates) SDN ch 51 18th April 2012. Thanks for keeping an eye out though.
Best regards to all
Brian
| link to this comment |
B
Sandy Heath (Central Bedfordshire, England) Full Freeview transTuesday 13 December 2011 7:15PM
March
It appears that the Tx'er info above is out of date ie: Sandy Heath Mux C is now channel 52 (frequency ? )
Brian
| link to this comment |
So Sandy Heath Mux A (SDN) remains ch 31 until 9th May ? Then ch 51? Is this correct, haven't seen any information regards date change (I understood it was going to be today 18/4/12 Comments please
Brian
| link to this comment |
When will the Sandy Heath Tx'r info in the table above be updated (assuming it will be.
Primarily to show SDN om mux A (Com 4)now being channel 51 (Frequency 714 MHz)
Regards Brian
| link to this comment |
Page 1
Saturday 10 September 2011 11:16AM
March
Currently residing at pe15 9nz. Ihave had to retune my Humax 9300T PVR manually. When I use auto tune, other frequencies/channels cause the pvr guide to not work properly. I thought I had this down pat, however i am now confused as to which channels I should be tuned to at this time? (is it 21, 24, 27, 31, 40 & 67) I realise this wouold change again next week.