All posts by Bill
Below are all of Bill's postings, with the most recent are at the bottom of the page.
Any thoughts on this Sudbury problem ?
My TV will not tune the Ch60 output (Pick TV etc), it pauses as expected while tuning but never reports any channels.
However my PVR and PC are still receiving Ch60 just fine, as was the TV until I did a retune a couple of weeks back.
At CM9 6HG, a clear view of the mast, and all other MUX are full strength and no pixellation or errors.
TV is Sony.
| link to this comment |
Bill:
Now fixed.
There wasn't a factory reset for tuning (everything but...) so I did a scan with no aerial lead to blank it out.
The subsequent automatic scan went OK, and a manual tune of Ch60 also picked up what it should have done this time.
Bit of a mystery, perhaps down to scanning in 'odd' weather.
Thanks
| link to this comment |
Friday 26 July 2013 12:48AM
Sudbury from CM9 postcode. Missing a MUX at rescan
I cannot rescan ch60 (Arquiva A Mux, the one with Pick TV on it) on my TV (Sony).
However my other receivers still receive it fine so there is plenty of signal (a Sony PVR and a PC).
The TV scan stops and 'thinks' at Ch60 but does not pick up any channels with an auto or manual scan.
All off the same aerial, might there be something wrong with the indexing data ?
Nothing obvious to me with TSReader.
Bill