All posts by Mr Naseem Shafi
Below are all of Mr Naseem Shafi's postings, with the most recent are at the bottom of the page.
M
Crystal Palace (Greater London, England) Full Freeview transmitMonday 15 October 2018 8:34PM
Woking
Post code is GU22 8EY
| link to this comment |
Thanks MikeP for the response. All available channels were fine and nothing been added or removed, just seems a bit strange just COM6 channels are affected. Will go through your comments and see what the issue is.
| link to this comment |
Just to update all the problem is now resolved. Would appear to be a connection issue in my setup. Many thanks to all who helped.
| link to this comment |
Well I thought the issue was resolved but back to square one. To recap certain channels come up 'no signal' and then some time later same channels are ok i.e. all available channels are ok none missing. so I am at a loss as what's going on. How can they be ok one minute and then gone the next?
| link to this comment |
Have checked all cable connectors etc, but what I can't understand is not touching anything all channels are ok so you think great problem solved, but then some channels just appear no signal & then again leave it i.e. do nothing and the channels that were ' no signaling' are back ok! Not sure about a 4g mast but the amp dist I have has a 4g filter. My postcode is GU22 8EY.
| link to this comment |
Using my tv's signal condition function I went through all available channels to see what's going on and on the whole the majority were 100% for strength and quality, however the channels that are on com7 and 8 multiplexes were funcualting up and down but ok for the picture and sound to be ok to view. Some were 0% for quality and 93% for strength and this caused a no signal issue. So that's the issue I have sometimes com7 and 8 are ok even though the strength & quality is going up/down, other times the same channel is 0% for quality but 93% for strength resulting in a no signal situation. Is the issue my end or crystal palace's end or both? Yes the aerial is pointing at crystal palace and is a wide band one.
| link to this comment |
Just to add I can understand if I was near the transmitter but I am about 34 km away so too much signal shouldn't be a problem I would of thought however I have ordered the atteuator as you said which I will give a go. Also checked all channels last night and all good, the affected ones were showing low signal strength and quality but picture and sound was ok. You would not know the signal was soo low the picture and sound were that good without any break up. Both com 7 & 8 multi plexes are less power that the other ones so that might have a bearing on my issue.
| link to this comment |
Page 1
Sunday 14 October 2018 2:26PM
Transmitter engineering: Channels on COM 6 are pixelated/sound breaks but all other channels are OK just the ones on COM6. Any ideas?